Despatch Protocol Manager with Protocol Plus Manual de usuario Pagina 31
- Pagina / 57
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Protocol Manager Software E-100
27
Reading/Writing a Recipe to/from a Controller
1. Select the controller from the box at the bottom right corner of the Recipe
Editor screen. See Figure 25. Only controllers that are currently enabled and
Online will be listed in the box.
Figure 25: Read/Write Area, Recipe Editor Screen
2. Select a profile (1 through 8) to be read/written from/to the controller.
3. Press the READ or WRITE button to either call up the recipe from the
selected controller, or write the current recipe to the selected controller.
NOTE: Reading the parameters from a controller will overwrite any information stored in
the displayed recipe.
- Protocol Manager 1
- Network Utility Software 1
- INSTRUCTION MANUAL 1
- Revision History 2
- TABLE OF CONTENTS 4
- INTRODUCTION 5
- INSTALLATION 6
- Host Computer Requirements 6
- Installing the Software 6
- Figure 2: License Agreement 7
- Figure 4: Install Screen 8
- Software Setup 10
- Startup and Login 11
- Comm Setup 14
- Network Setup 16
- Windows Setup 19
- Configuring a Recipe 26
- Note on Standby Mode 29
- Creating a New Recipe 29
- Opening an Existing Recipe 30
- Recipe Selection Setup 32
- Datalog Functions 34
- Log File Header Information 35
- Log File Record Data 36
- Log File Naming Options 37
- STARTING THE CONTROLLER 39
- Run Time Window 40
- Timer Mode 41
- Profile Mode 42
- AND JUMPER SETTINGS 44
- Wiring Diagrams 44
- Single Oven 48
- Multiple Ovens 48
- TROUBLESHOOTING THE 52
- COMMUNICATIONS OPTION 52
(58 paginas)
Comentarios a estos manuales